Connection between Netmore LNS and MClimate Enterprise
In order to properly create a Netmore integration with MClimate Enterprise you need to configure your Application to connect Enterprise platform.
Configuring the MClimate Enteprise integration
Head over to the link https://enterprise.mclimate.eu/ and log into your account. Go to the Integrations section and create a new M-token (you only need to enter a name).
M-token creation
Make sure to copy and save it as you will need it later.
Copying the M-token
Next, open up the Netmore integration.
Netmore integration
You need to fill in the requested field where:
M-token - the value of the M-token you just created
User - the username for your Netmore account
Password - the password for your Netmore account
RAK WisGateOS2 Integration
Configuring the Netmore platform integration
Log into your Netmore account and open up the navigation menu in the top right. Select Service Providers -> MClimate
Service Providers -> MClimate
Open up the Export Configs section (refer to the image below).
Export Config
Create a new configuration via the button (refer to the image below).
New Export Config creation
In the configuration window fill in the parameters, where:
Finally create a single Header with the following parameters
Name - m-token
Value - "the value of the Mtoken you created in the previous step"
Your configuration should be similar to the one below.
Configuration parameters
You should see your new Configuration listed.
Configuration list
The last step in the process is to apply the Configuration to your sensor device. Open up one of the sensor you intend to use with MClimate Enterprise, and select the newly created Export Config.
Export Config selection
You should see the newly created Export Config in the drop down menu.
Enterprise Export Config
The settings are applied immediately upon selection. If you have configured everything as per our instructions the traffic from your MClimate sensors will be connected with the MClimate Enterprise platform now.
This guide assumes you have already provisioned the sensor on the Netmore platform. If you have not please refer to the official documentation from Netmore as this is out of the scope of this document.
