МClimate 16A Dry Switch (16ADS)

988KB

MClimate-16ADS-Datasheet.pdf

PDF

Open

Datasheet

894KB

16ADS-User-Manual.pdf

PDF

Open

User Manual

889KB

16ADS-LoRaWAN-Mounting-Instructions.pdf

PDF

Open

Mounting Instructions

General Information

The МClimate 16ADS is a miniature device that features a 16A dry relay. The device is small enough to fit behind most wall switches and outlets. The device operates in LoRaWAN Class C, features FUOTA (Firmware Upgrades Over The Air) and has overheating protection

Learn more about MClimate Smart Building Solutions:

Smart Buildings - Scalable LoRaWAN & NB-IoT Solutions by MClimateMClimate

Power supply

• Mains powered

  • Voltage range - 100-240VAC / 24-30VDC

  • Consumption - 50mA

Output circuit rating

• Max. switching voltage - 240VAC / 30VDC

• Max. switching current - 16A AC (8A AC for $cos \varphi = 0.4$) / 10A DC

• Max. switching power - 3840 (2000W for $cos \varphi = 0.4$) / 300W DC

Safety functions

• Overheating protection

Supported load types

• Resistive - incandescent bulbs, heating devices

• Capacitive - capacitor banks, electronic equipment, motor start capacitors

• Inductive - LED light drivers, transformers, fans, refrigerators, air-conditioners

Radio / Wireless

• Wireless technology - LoRaWAN 1.0.3

• Wireless security - LoRaWAN End-to-end encryption (AES-CTR)

• LoRaWAN device type - Class C End-device

• Supported LoRaWAN features - OTAA, ADR, Adaptive Channels setup

• Supported LoRaWAN regions - EU868 - 870; Other LoRaWAN regional settings available upon request

• Link budget - 130dB

• RF transmit power - 14dB

Sensors

Temperature sensor

• Resolution: 0,1°C

• Accuracy: ±0,2°C (typ) - ±0,7°C (max)

Wiring diagram

The diagram below should be adhered to strictly, lest you risk damaging the device. The diagram is a representation of the device as seen from the side where the terminals are exposed (their screws).

16ADS Wiring diagram

Placement Guidelines

The device is intended for installation in console boxes, panels and in places that provide an insulating shell of at least 5mm to cover current-carrying parts or other conductive parts!

The device must be mounted to non-conductive surfaces!

The device must be installed in a place that ensures good cooling. Install vertically for improved cooling!

To be used only as a control device and not as a protection device!

If you have any questions, feel free to reach out to us at [email protected]