The МClimate 16A Switch & Power Meter LoRaWAN (16ASPM) is a miniature device that features a wet 16A relay and an electricity meter inside. The device is small enough to fit behind most wall switches and outlets. The device has 4 terminals Lin, N, N, Lout, connecting and disconnecting Lout from Lin. The device operates in LoRaWAN Class C, features FUOTA (Firmware Upgrades Over The Air) and has overheating protection
Learn more about MClimate Smart Building Solutions:
Supported LoRaWAN features - OTAA, ADR, Adaptive Channels setup
Supported LoRaWAN regions - EU868 - 870; Other LoRaWAN regional settings available upon request
Link budget - 130dB
RF transmit power - 14dB
Sensors
Voltage sensor
Resolution - 0.1V
Accuracy - ±1%
Current sensor
Resolution - 0.01A
Accuracy - ±1.5%
Current below 100mA is not registered and measured, thus a device consuming less than this threshold would produce keep-alives with 0 values for the current, power and the accumulated energy will not increase.
This will not impact functionality otherwise and the connected appliance will still be powered correctly.
Electricity meter
Resolution - 0 . 01kWh
Accuracy - ±1.5% accuracy @ 10A 230VAC
Internal temperature sensor
Resolution: 1°C
Accuracy: ±1°C
Wiring diagram
The diagram below should be adhered to strictly, lest you risk damaging the device. The diagram is a representation of the device as seen from the side where the terminals are exposed (the screws are visible).
16ASPM Wiring diagram
Placement Guidelines
The device is intended for installation in console boxes, panels and in places that provide an insulating shell of at least 5mm to cover current-carrying parts or other conductive parts!
The device must be mounted to non-conductive surfaces!
The device must be installed in a place that ensures good cooling. Install vertically for improved cooling!
To be used only as a control device and not as a protection device!
If you have any questions, feel free to reach out to us at [email protected]
